Waterproofing Hard Defense Elastic Fibers

Package

Bucket 18 Kg

PROPERTIES

Chemical base: Acrylic with fibers
Density: 0.95 to 1.05 g/cm³
pH : 8 to 10 Ph
VCO – SCAQMD Method 304-91: 15.35 g/l

NOTES

Shelf life: 12 Months
Storage temperature 10 to 35°C
Substrate temperature 10 to 35°C
work temperature up to 80°C
Application temperature 5 to 35°C

Check the surface where the product will be applied: 

Cleaning:  The surface that will receive the Membrane should be free from grease, oil, and be dry, clean and leveled with mortar of good resistance. Check the area: Check the substrate conditions, and in the case it is releasing particles and with low adhesion, the PRIME COAT should be performed, according to the instruction below.

Primer preparation: Mix it at a ratio of 1:1:1 (1 part of Hard Defense Fibers + 1 part of cement + 1 part of water).

Apply the primer: Mix this ration and apply in one layer on the surface with painting roll or broad brush. Do not let the solution to pool in the substrate, application can be made with broad brush, roller, or brush.

Apply the membrane:

Step 1 – Prepare the ratio

The ratio to apply the membrane should be 1:1, that is, 1 (one) part of Hard Defense Elastic and 1 (one) part of cement without lumps (screened).

Note: The type of cement can vary according to the environment to be waterproofed.

Step 2 – Mix

Put the ratio of products to be prepared in a clean container, mix it mechanically 3 to 5 minutes until a homogeneous mix without lumps is obtained.

Step 3 – Application

Apply it with a brush or a broad brush beginning by the strainers and baseboards;

On baseboards, application should be at least 10 cm on the floor and 10 cm on the wall;

On strainers, cover 40 cm x 40 cm and 5 cm in the PVC pipe inner part.

Apply in a way to paint the entire floor and wall area with the brush, wool roller with height of 19 mm or broad brush;

Wait until it is touch dry.

Apply the 3^rd coat.

Important: always dampen the brush, broad brush, or roller with the mixture, in order to assure a good coating in each coat.